EXPERIMENTAL INVESTIGATIONS ON MRR AND SURFACE ROUGHNESS OF EN 19 & SS 420 STEELS IN WIREEDM USING TAGUCHI METHOD

Based on these assumptions, the main purpose of this study was to evaluate the effect of tillage treatments on soil surface roughness (RR) and tortuosity (T) and to investigate

Objective: This study aimed at assessing the effect of different adhesive remnant removal methods on enamel topography (ESI) and surface roughness (Ra) after bracket debonding

The parameters analyzed in the tests are: surface roughness (using bosses on the bonded phase of diferent thicknesses), compressive strength with monotonic and cyclic loadings.

The inluence of cutting speed, feed rate and radial depth of cut on various machinability characteristics such as maximum temperature ( T max ), surface roughness ( R a ) and

Initially, surface roughness is positively affected by the wear progress to different extents depending on wear rate. On reaching a wear level above 0.2 mm, surface roughness tends

All above listed papers concluded that surface roughness parameters of steels increase with increasing feed rate but decrease with increasing the cutting speed and the depth

Experiments on important EDM electrical and non- electrical parameter settings with reference to material removal rate, electrode wear ratio and surface roughness were carried

Portanto, a partir da pesquisa de campo, infere-se que a relação entre os habitantes do quilombo de São Tomé de Tauçú, seu modo de vida tradicional quilombola