• Nenhum resultado encontrado

Design and Simulation of Fuzzy Logic controller for DSTATCOM In Power System

N/A
N/A
Protected

Academic year: 2017

Share "Design and Simulation of Fuzzy Logic controller for DSTATCOM In Power System"

Copied!
8
0
0

Texto

Loading

Imagem

Fig. 1.    Block diagram of system
Fig. 4.    Fuzzy rule
Fig. 6.    Fuzzy rule
Fig. 11. Waveforms of Load Voltage, Nonlinear load current, balanced source current, source voltage with application of nonlinear load

Referências

Documentos relacionados

It was presented three ways to work with the Fuzzy controller, namely: (a) Fuzzy supervisory controller of the gain matrix of the LQR control ( G ), (b) Fuzzy controllers in an

The adaptive fuzzy controller is designed through the following steps: first, construct an initial controller based on linguistic descriptions (in the form of fuzzy IF-THEN rules)

To perceive the effectiveness of the control scheme proposed in this paper, we have simulated both the fuzzy logic controller and its optimization with the

µ-based UPFC controller synthesis: The main goals of the UPFC controller design are: Power system oscillation damping, DC-voltage regulator and power flow

Temperature input variable: By using the fuzzy set, the operation of fuzzy controller is to determine the percentage of valve open (v) for each pressure level to

Results: Simulation results showed that the use of intelligent fuzzy logic and nero-fuzzy controller improved the data transmission rate and decreased long delay when compared

By introducing the trust scheme into the fuzzy logic scheme to represent the reliability of the nodes, a cooperative spectrum sensing scheme based on trust and fuzzy logic for

The optimum fuzzy logic control of an induction generator require controller which will track wind speed in order to achieve λ opt and thus extract