Method of Obtaining a Composite Material Based on Small-Dispersed Particles
Texto
Documentos relacionados
The probability of attending school four our group of interest in this region increased by 6.5 percentage points after the expansion of the Bolsa Família program in 2007 and
Performed tests have shown that application of phosphorus in form of CuP10 and AlSr10 master alloy as an inoculant gives positive results in form of refinement of primary crystals
Power demand of the mixer’s drive reveals the mixer’s operating characteristics and reliable monitoring of the mixing processes involving the evaluation of power consumption
The two points considered at the alternate sides, of the tangents through the diameter of the circle, and then the line joining these points divides the circle
At the first stage of the measurements results analysis, the gear wheel cast surface image was compared with the casting mould 3D-CAD model (fig.. Next, the measurements results
social assistance. The protection of jobs within some enterprises, cooperatives, forms of economical associations, constitute an efficient social policy, totally different from
Fractures were made in all samples. Figure 1 shows fractures of test bars cast from the examined high-aluminium iron in base condition and with the addition of vanadium
Haratym, Dok ł adno ć wymiarowa odlewów wykona- nych w procesie Replicast CS, Archiwum Odlewnictwa rocznik 3, nr 9, Katowice 2003.. Arendarski, Niepewno ć pomiarów, Oficyna