• Nenhum resultado encontrado

Effect of thermal and mechanical cycles on the hardness and roughness of artificial teeth

N/A
N/A
Protected

Academic year: 2017

Share "Effect of thermal and mechanical cycles on the hardness and roughness of artificial teeth"

Copied!
7
0
0

Texto

Loading

Referências

Documentos relacionados

The susceptibility of a duplex stainless steel UNS S31803 to thermal embrittlement at 475 °C was evaluated by means of mechanical tests (impact energy and hardness),

O bjectives: To evaluate the color stability and hardness of two denture liners obtained by direct and indirect techniques, after thermal cycling and immersion in beverages that

The degree of conversion of the composite resin specimen is usually assessed by the hardness ratio, the ratio between the upper surface hardness value of the control group and

when associated with regular fluoride dentifrice on demineralized enamel using surface hardness and cross section hardness in a pH-cycling model, simulating oral cavity

Water glass modification with the colloidal solution of ZnO nanoparticles in propanol confirmed the effect of modifier on the water glass wettability of sand

Results of investigations of influence of small vanadium up to 0.3%, niobium up to 0.16% and nitrogen up to 58 ppm additions and heat treatment of 1080 o C-24h/640 o C and 1080

Basing on the results of MANOVA test it has been observed that the strongest significant effect on an increase of the tensile strength R m exerted the addition of Mg, followed by

In conclusion , conventional and boiled polymerization cycles produced similar effects on gloss, roughness, hardness and impact strength of both Classico and QC-20 acrylic