EXPERIMENTAL INVESTIGATION ON ELECTRICAL DISCHARGE MACHINING OF TITANIUM ALLOY USING COPPER, BRASS AND ALUMINUM ELECTRODES

wear rate; coefficient of friction versus roughness; and coefficient of friction versus wear rate is obtained, respectively, for epoxy based and waste material blended

The objective of the present investigation is to study the effect of beryllium doping on the structural, optical, and electrical properties of CdO, focusing on the improvement

Initially, surface roughness is positively affected by the wear progress to different extents depending on wear rate. On reaching a wear level above 0.2 mm, surface roughness tends

The EDS of the base material has been presented for reference purpose and it is clearly observed that the amount of carbon, copper and aluminum elements are

This paper reports the experimental investigation carried out on EDM to study the effects of machining parameters such as pulsed current on material removal rate, depth of cut,

In the present paper an attempt has been made to study the effect of input parameters such as cutting speed, feed rate and depth of cut on Surface roughness, Tool wear,

In this paper a practical method of optimizing cutting parameters for electrical discharge machining under the minimum total machining time based on Taguchi method and

The present work focuses on the surface finish of threaded titanium alloy Ti-6AL-4V using a coated carbide tool under a dry machining condition.. Thread