Mat. Res. vol.15 número3
Texto
Imagem
Documentos relacionados
The purpose of this study, therefore, was to evaluate the performance of plywood produced with the wood spe- cies Eucalyptus grandis based on its physical and mechani- cal
Shown below are the results of the density, moisture, swelling in thickness, absorption and static flexure tests obtained for the panels produced with polyurethane resin and
The results obtained for Pt films deposited at 700 ° C over Ti and Zr buffer layers are shown in Fig. Comparing films with the same thicknesses, the room temperature resistance and
The spheres are droplets of molten material from the target and they cannot be avoided by manipulating the deposition parameters (temperature, pressure or laser fluence). Even when
X-ray photoelectron spectroscopy (XPS), also called elemental spectroscopy for chemical analysis (ESCA) is a very important technique to identify chemical species on materials
Several reports have shown the influence of different factors such as grain size, type and amount of binder phase and the addition of hard particles on the properties of WC-Co..
In this way we will attempt to verify the influence of some types of cutting fluids on the cutting tangential force behavior, on the workpiece superficial roughness, on the
Figure 2. Panel a) shows the PL spectra of the as-grown multilayer samples A and B (dotted lines) taken at 10 K. The corresponding spectra after the annealing at 500 °C are shown