• Nenhum resultado encontrado

Identification of boundary heat flux on the continuous casting surface

N/A
N/A
Protected

Academic year: 2017

Share "Identification of boundary heat flux on the continuous casting surface"

Copied!
6
0
0

Texto

Loading

Imagem

Fig. 1. Rectangular cast slab
Fig. 2. Transition  t f − 1 → t f using future time steps (R = 4)  In the sequential function specification method the sensitivity  coefficients are used (c.f
Fig. 3. Discretization
Fig. 4. Temperature at the points A, B, C, D, E

Referências

Documentos relacionados

The Direct Problem is composed of the heat conduction equa- tion, with boundary conditions of the irst kind and is solved by the Central Finite Differences Method, with the explicit

The heat transfer coefficient increased with increasing heat flux and mass velocity, but strong heat flux dependence was observed, mainly in the lower vapor

Remelted zone of the probes after treatment with current intensity of arc plasma – 100 A, lower bainite, retained austenite and secondary cementite.. Because the secondary

[27], the absorbing heat flux and releasing heat flux of the fifth endoreversible Carnot heat engine can be obtained by using the heat transfer between the working fluid and

This paper brings to focus the heat transfer in a boundary layer flow of Sisko fluid over a nonlinear stretching sheet with variable wall temperature and heat flux boundary

The structure of the remelting zone of the steel C90 steel be- fore conventional tempering consitute cells, dendritic cells, sur- rounded with the cementite, inside of

An analytical study based on bifurcation and stability of fixed points shows that at low value of heat flux the plasma is governed by neoclassical regime and at higher heat flux

The OSEB and SEBAL models were used to estimate the partition of net radiation ( Rn ) into the components latent heat flux (LE), sensible heat flux (H), and ground heat flux