• Nenhum resultado encontrado

The Effect of Mixing Energy and Shear Rate on the Thickening Time of Cement Slurry

N/A
N/A
Protected

Academic year: 2017

Share "The Effect of Mixing Energy and Shear Rate on the Thickening Time of Cement Slurry"

Copied!
12
0
0

Texto

Loading

Imagem

Table 2. Showing mixing energy and Thickening Time at different rotational speed and time  Experiment Rotational  Speed(rpm)  Time(Sec) Mixing  Energy(kJ/kg) Total Mixing  Energy(kj/kg)  Thickening Time(mins) 4000 15  0.27  1  12000 35  5.62  5.89 150  400
Figure 2. Thickening time chart for experiment 2
Figure 4. Thickening time chart for experiment 4
Figure 5. Thickening time chart for experiment 5
+2

Referências

Documentos relacionados

Por fim, na terceira parte, estudo de caso, tendo em conta todo o enquadramento teórico anteriormente desenvolvido, foram aplicadas todas as temáticas à realidade da Vortal,

ECONÔMICAS SOBRE OS NÃO CONVENCIONAIS NO BRASIL – OTC BRASIL, organizado pela IBP - Instituto Brasileiro de Petróleo, Gás e Biocombustíveis, realizado no dia 30 de outubro, no

This article presents a quantitative and comparative analyses between the forces maintaining stratification (surface heating; rainfall precipitation; and differential advection of

This study aimed to evaluate the effect of 4 different desensitizing agents containing different amounts of fluoride on the shear bond strength of a dual polymerized resin cement and

The probability of attending school four our group of interest in this region increased by 6.5 percentage points after the expansion of the Bolsa Família program in 2007 and

medium by the addition of chemical modifiers and wetting agents, and antifoam agents); (iv) the mixing and homogeni- zation of the slurry (i.e., the use of

Thus, an investigation was made on the effect of fl ow rate and shear stress, adhesion time, and seeding density under direct perfusion in polycaprolactone electrospun scaffolds on

Shear stress versus shear rate for a water based drilling fluid and its statistical results. presented the highest values of shear stress and TT-100 the lowest (note that this