Effect of Thermo-Mechanical Treatments on the Microstructure and Mechanical Properties of the Metastable β-type Ti-35Nb-7Zr-5Ta Alloy

Besides the evaluation of the specimens after the end of the tests, this section involves the stress-strain curves according to the temperature considered, obtaining the

Mechanical properties of the rolled sheets Figure 6 shows the effect of the rolling reduction amount on the Vickers Hardness HV for ZK60 alloy sheets produced by TRC

Analysis of the chemical composition, hardness and wear tests showed that the effect of bead overlapping on coating features is most pronounced in the first and second beads.

Performed tests have shown that application of phosphorus in form of CuP10 and AlSr10 master alloy as an inoculant gives positive results in form of refinement of primary crystals

Water glass modification with the colloidal solution of ZnO nanoparticles in propanol confirmed the effect of modifier on the water glass wettability of sand

Descriptive statistics for measuring the surface area the primary precipitates of intermetallic phases IM_W\ κ I (Sap_IM_W\ κ I, μ m 2 ) depending on the annealing time ( τ _ia,

Basing on the results of MANOVA test it has been observed that the strongest significant effect on an increase of the tensile strength R m exerted the addition of Mg, followed by

His research interests mainly focus on TiAl alloy preparation; microstructure and mechanical properties of bulk nanostructured and ultraine grained Ti based alloys and