Mat. Res. vol.18 número1
Texto
Imagem
Documentos relacionados
In the present article, the inluence of applying ion beam nitriding to a 100Cr6 bearing steel prior to the deposition of TiN ilms by IBAD was investigated..
Tensile failures occurred at the weld zone in all the weldments. As discussed in the earlier sections, the hardness trend had clearly represented the lower hardness values at
The level of heat treatment temperature showed more pronounced effect on the physical and mechanical properties of particleboard obtained from bagasse than the exposure time..
comparison between Figure 4a (conventional sintering) and Figure 4b (microwave sintering), it can be noticed that the dependence of both average grain size and relative density
The geometry attained at the end of the pre-forging simulation, the effective strain distribution, the strain rate distribution, the dynamically recrystallized volume fraction
The aim of the present work was to determine the effect of adding RVFM on the ceramic properties of clay, such as apparent porosity, water absorption, linear shrinkage and
In the second stage, the remaining material is loaded in an oven with controlled temperature to incinerate the polymer residues and recover only the Al 2 O 3 :C crystalline
Commercial glass iber reinforced-vinyl ester resin composite pipes used in onshore and offshore utilities were exposed to the action of luids that could normally come into contact