Effect of hot extrusion process on microstructure and mechanical properties of hypereutectic Al-Si alloys

In overall, the formation of new strain-free grains associated with {111}//ND and {110}//ND directions corresponded to the dense planes in BCC structure, regardless to the fact that

The values of the yield stress of the composite processed by ECAP at room temperature are somewhat higher than those of the composite processed at 150°C which is quite consistent

For the resulting program there were developed variants of the corresponding methods of cooling chill in the Table 1.The study of sequential cooling effect of

Compared with as-cast AZ80 alloy, yield strength of the alloys with solid solution treatment remarkably decreased, while the tensile strength and ductility increased

The effect of nanometric zirconia particle additives on microstructure and mechanical properties of dense alumina.. Lukasz Zych, Radoslaw Lach, Krzysztof Haberko * , Pawel

Descriptive statistics for measuring the surface area the primary precipitates of intermetallic phases IM_W\ κ I (Sap_IM_W\ κ I, μ m 2 ) depending on the annealing time ( τ _ia,

Basing on the results of MANOVA test it has been observed that the strongest significant effect on an increase of the tensile strength R m exerted the addition of Mg, followed by

The higher the fraction of solid phase in the partly solidified melt during pouring, the poorer the mechanical properties of thixocast components.. The solid fraction decreases as