• Nenhum resultado encontrado

J. Braz. Soc. Mech. Sci. & Eng. vol.34 número3

N/A
N/A
Protected

Academic year: 2018

Share "J. Braz. Soc. Mech. Sci. & Eng. vol.34 número3"

Copied!
9
0
0

Texto

Loading

Imagem

Figure 1. Various stages of cutting tool wear.
Table 2. Chemical composition of Al 6063 in % of weight.
Figure 5. Hybrid GA and ANN prediction model .Input parameters
Table 5. Details of ANN topology.  S. No.  Name of  the layer  Number of neurons  Parameters  1  Input  4  cutting speed feed velocity  depth of cut  fluid flow rate
+3

Referências

Documentos relacionados

The vertical water entry of a two-dimensional circular cylinder at constant velocity is computed using both linear analytical solution and fully nonlinear numerical

During the second half-time of the bubbles expansion a water film was formed at the wall of the container, which propagated upwards even when the water

negligible and consequently the heat sink overall resistance (Eq. The main objective of this work is to demonstrate that the hollow fin vapor chamber approach leads to

The aim of this paper is the analysis of dam break flows by considering various numerical aspects of smoothed particle hydrodynamics, such as time stepping

Taguchi’s quality loss function approach, a multi-response optimization method, has been employed to determine the best combination values of cutting speed, feed,

Metal cutting operation was performed at eight different rake angles, three various cutting speeds and cutting depth for the experimental work done about the

Flexural-Torsional Vibration Analysis of Axially Loaded Thin-Walled Beam The present paper considers the flexure-torsion coupled vibrations of axially loaded thin- walled beams

The bending strength was heavily influenced by the formation of graphene pileups into the epoxy matrix and its dispersion around the carbon fibers.. This