An Experimental Study of the Solidification Thermal Parameters Influence upon Microstructure and Mechanical Properties of Al-Si-Cu Alloys
Texto
Imagem
Documentos relacionados
In order to observe the efect of growth velocity and Fe content on microstructure and mechanical properties of Al–1.9Mn–xFe alloys, eutectic rod spacings, microhardness and
For the Al-Si5Cu3 alloy the results obtained in this work confirm that cooling rates influence the nucleation and growth of α c -Al 15 (Fe,Mn) 3 Si 2 and β- Al 5 FeSi phases.
corner of Al-Cu-Si phase diagram, dashed lines show the univariant binary eutectic Al-Si and Al-Cu reactions. Figure 2 shows Al-rich corner of Al-Ag-Cu phase diagram, dashed
The effect of solidification processing parameters ( Sp and Ṫ ) and Si content on the secondary dendritic arm spacing (λ 2 ) and resulting hardness in hypoeutectic Al-Si alloys
shows calculated phase diagram of the Bi-In system using optimized thermodynamic parameters from the COST 531 database 15 , which are based on the thermodynamic assessment by Boa
Measurements of microhardness during transient horizontal directional solidification of Al-rich Al-Cu alloys: Effect of thermal parameters, primary dendrite arm spacing and
When the milled sugarcane bagasse was used as carbon source, the windrow presented the highest amount of P in its constitution and presented, in the evaluation averages, a greater
In the Porto series, we observed that, independently of the tumour type, 2 tumours co-expressing GLUT1, MCT4 and CD147 presented with synchronous metastasis and 2 other