J. Braz. Soc. Mech. Sci. & Eng. vol.31 número4
Texto
Imagem
Documentos relacionados
(2001) also showed that the total machining cost per part, assuming only direct costs, consists of three elements: the independent cost on Cs , (part material cost
The motor torque controls the joint angle tracking and decreases the low frequency link vibration, while piezoelectric sensor and actuator are added to control the
As previously predicted by the finite element method, the experimental electrical impedance curve shows that there is a mode coupling between the first thickness mode ( f t =
To achieve this aim, we use the Navier-Stokes equations; the finite volume method; co-located arrangement of variables; segregated solution for the three
6 suggest that for a fixed blood flow rate, the dependence between the final temperature of the fluid inside the endometrial balloon and the depth of the affected
The 55%Al-Zn coated steel showed higher yield and tensile strength and lower total elongation and hardening coefficient compared to zinc coated steel and the coating showed
and Li, Y., 2002, “A combined temperature scale for analyzing natural convection in rectangular enclosures with discrete wall heat sources”, International Journal of Heat
The tests carried out for two-dimensional flow disturbances in the non-linear regime showed that the current code can recover the classical secondary instability