• Nenhum resultado encontrado

ANALYSIS AND OPTIMISATION OF DYNAMIC STABILITY OF MOBILE WORKING MACHINES

N/A
N/A
Protected

Academic year: 2017

Share "ANALYSIS AND OPTIMISATION OF DYNAMIC STABILITY OF MOBILE WORKING MACHINES"

Copied!
8
0
0

Texto

Loading

Imagem

Fig. 1. Loss of mobile working machine stability during operation  Rys. 1. Spadek stabilno ci w mobilnej maszynie roboczej podczas pracy
Fig. 2. Dynamic model of a wheeled mobile working machine    Rys. 2. Model dynamiczny ko łowej mobilnej maszyny roboczej
Fig. 3. Time behaviours of the    t  function for the various values of the   t     Rys
Fig. 4. Dynamic stability of the mobile working machine without travelling   Rys. 4. Stabilno ć dynamiczna mobilnej maszyny roboczej podczas postoju
+2

Referências

Documentos relacionados

The probability of attending school four our group of interest in this region increased by 6.5 percentage points after the expansion of the Bolsa Família program in 2007 and

To the best of the author’s knowledge, the dynamic stability of rotating cantilever wings subjected to inclined follower forces by using the geometrically exact fully intrinsic beam

Copper addition, as it is used in cast steel grades implemented in Polish power industry applications, decreases the temperature of the end of solidification, thus affecting

Performed tests have shown that application of phosphorus in form of CuP10 and AlSr10 master alloy as an inoculant gives positive results in form of refinement of primary crystals

Because of the increas- ing the speed of the decomposition of the anhydrite, together with the growth of the temperature of casting the bronze to the plaster mould, the gases

The two points considered at the alternate sides, of the tangents through the diameter of the circle, and then the line joining these points divides the circle

The method of stabilography control of body balance function permits to timely evaluate static-dynamic stability of body and functioning of vestibular system as well as

Stability parameters (margin of stability – MOS, center of mass separation – COM SEP , and time-to-contact – TtC) obtained by analysis of the COM displacement relative to the base