• Nenhum resultado encontrado

J. Braz. Soc. Mech. Sci. & Eng. vol.27 número4

N/A
N/A
Protected

Academic year: 2018

Share "J. Braz. Soc. Mech. Sci. & Eng. vol.27 número4"

Copied!
7
0
0

Texto

Loading

Imagem

Figure  1a.  Streamlines  in  the  driven  cavity  flow  Re  =  300,  grid  40 ×××× 40,  εεεε =0.0001
Figure  4.  Velocities  distribution  u  in  medium  section  of  deep  cavity  flow.
Figure 6. Streamlines in the channel flow with multiple obstacles Re = 20 - grid 26x96,  εεεε =0.0001

Referências

Documentos relacionados

The method described here is thus suited to radiative transfer problems characterized by different layer types and with a left boundary condition expressed as a

Calculations show that the stagnation point heating on power law leading edges with finite radius of curvature follows the same relation for classical blunt body in continuum flow; it

Using a pattern classifier implemented by neural networks it is possible to classify patterns of ultrasonic signals from welds by the pulse echo technique and by the

The idea was to determine the distribution of temperature, heat flux, thermal gradient, cooling curves in the cast metal, and heating or/and cooling in the molds

resin transfer molding (RTM), resin film infusion (RFI), and hand lay-up, the problem of void formation is also related to the manufacturing process parameters such as fiber

In the present paper a vertex centered finite volume formulation using median dual control volumes is developed and implemented for the simulation of axisymmetric

The scheme described above has already been utilized for the simulation of a variety of applications (Antunes et al., 2002, An- tunes and Lyra, 2002 and Antunes, 2002),

Since the supply pressure, the flow coefficient of the valve and the cushioning factor are experimental data, one can observe that the dynamic model employed describes