J. Braz. Soc. Mech. Sci. & Eng. vol.25 número4
Texto
Imagem
Documentos relacionados
These last two physical models defined by Nelson and Crandall [5] correspond to a model of discrete mass of the coupling, in which too small values of translational and
Considering maximum reaction zone temperature, high blowout mass flow rate, low ignition delay and low NO production it was found that water contents between 3 and 4 % volume
The simple model applied here, only to test the proposed experimental method, resulted quite well in matching the experimental data, although clearly shows that there are huge
Authors have evaluated the use of alternatives cooling techniques to minimize this effect (Yun Li et al, 2000). The objective of these researches is to reduce the SL resin
The flow around a rigid fixed bridge cross-section, as well as the flow around the same cross-section with torsional motion, are investigated to obtain the aerodynamic
Keywords: Boundary element method, hypersingular formulation, cauchy principal value, finite part
The control algorithm is based on two independent neural models, the first one being responsible for assessing the flow regime by defining proper target and gain values for
Some of the studies in Taylor-Couette flow have suggested that the flow structure is composed of large Taylor cells throughout the gap, typically due to the Taylor instability