• Nenhum resultado encontrado

J. Braz. Soc. Mech. Sci. & Eng. vol.26 número3

N/A
N/A
Protected

Academic year: 2018

Share "J. Braz. Soc. Mech. Sci. & Eng. vol.26 número3"

Copied!
10
0
0

Texto

Loading

Imagem

Figure 1. Hierarchical structure of a distributed manufacturing system.
Figure 2. Structure of a fault-tolerant machine.
Figure  4.  Modeling  of  fault  treatment  based  on  the  addition  of  subnets  (adapted from Zhou and DiCesare, 1993)
Figure 7. Manufacturing process modeled with PN (central-PN).
+5

Referências

Documentos relacionados

Detail of the artificial dissipation effect on the pressure coefficient distribution over the central vehicle forebody surface for a plane between two boosters for M ∞ = 0.9 and

The normal force results obtained for the Sonda III-A under the present effort are being used for actual design work without experimental verification.. Numerical Cp

The PIV measurement includes illuminating a cross section of the seeded flow field, typically by a pulsing light sheet, recording multiple images of the seeding particles in the

A finite element formulation based on Kirchhoff’s plate model has been developed for the analysis of smart composite structures with piezoelectric materials.. All important steps

Evaluation of Subsurface Contact Stresses in Railroad Wheels Using an Elastic Half-Space Model.. Railroad wheels fail in two main modes: rolling surface defects like

However, those research works consider that the necessary information for the analysis (e.g. the contacts among the parts in the assembly) is already available, which is

Much higher cutting speeds and feed rates can be achieved when machining aero-engine alloys with SPRTs, relative to conventional cutting tools, without pronounced adverse effect

(11) provides the circulation values for the wing vortex rings, which will be employed for the aerodynamic loads calculation.. The unsteady Bernoulli equation for each panel