• Nenhum resultado encontrado

Feasibility of a solar-assisted winter air-conditioning system using evaporative air-coolers

N/A
N/A
Protected

Academic year: 2017

Share "Feasibility of a solar-assisted winter air-conditioning system using evaporative air-coolers"

Copied!
10
0
0

Texto

Loading

Imagem

Table 1. Climate conditions in Central Sudan [9]
Figure 2. The evaporative winter air-conditioning system
Table 2. The model's estimations of the water flow rate for the tests reported by [8]
Table 4. Estimated useful time (in hours) of residential-size solar heaters for different air flow rates  500 cfm  1000 cfm  1500 cfm  2000 cfm  100-LPD 2.69  1.34  0.90 0.67  150-LPD 4.03  2.01  1.34 1.01  200-LPD 5.37  2.69  1.79 1.34  250-LPD 6.71  3.36
+3

Referências

Documentos relacionados

The efficiency of coating η as a function of the operational variables: spouted air flow rate, atomization air flow rate and slurry flow rate was obtained empirically by

Este trabalho teve como objetivo o desenvolvimento de um sistema automático da análise em fluxo baseado na metodologia SIA para a extração e determinação da

Ahsan and Fukuhara [1] studied on a new heat and mass transfer tubular solar still and found that the heat and mass transfer coefficients can be expressed as functions of

In Air-jet weaving machine number 4, we found that the opening to closing time of sub nozzles is higher than others four machines that is why it consumes higher amount

Apesar de não ser possível generalizar os resultados, o presente estudo demonstrou que dez sessões musicais foram suficientes para verificar alterações da F 0

The study included pulp drying (using air, solar and hot air methods); the production of briquettes and pellets; the evaluation of their energy, physical and mechanical properties;

.RG WHUPRKLGUDXOL NLK SURUD XQD YD]GXåQLK KOD GQMDND QHSR]QDWH VX YUHGQRVWL L]OD]QH WHPSHUDWXUH L PD VHQRJ SURWRND YD]GXKD 3R]QDYDQMH YUHGQRVWL EDU MHGQH RG RYLK YHOL LQD MH

In the past, this part was made of acrylonitrile-butadiene-styrene (ABS) by injection moulding process, but recently was changed to high impact polystyrene (HIPS)