• Nenhum resultado encontrado

Mat. Res. vol.15 número6

N/A
N/A
Protected

Academic year: 2018

Share "Mat. Res. vol.15 número6"

Copied!
6
0
0

Texto

Loading

Imagem

Table 1. Chemical composition of duplex (UNS S32205) and lean duplex (UNS S32304) steels.
Figure 3. Nominal stress versus nominal strain curves of a) DP  UNS S32205 and b) LD UNS S32304.
Table 3. Values of K, K 1 , K 2 , n, n 1  and n 2  obtained with one equation and two equations models for flow stress curves of duplex steel.
Table 5. Magnetizations saturation (m s ) of samples collected from  tensile tests specimens (after test).

Referências

Documentos relacionados

The results indicated two different mechanisms for sigma phase precipitation: sigma phase formed from the chi phase for shorter isothermal heat treatment times, and sigma

Figure 6. Crystallographic microtexture of duplex stainless steels S32304 of the samples as received, cold rolled and annealed.. ferrite, the components that were present in

The corrosion potential of DSS in industrial WL at 60 ºC was less noble than the value at room temperature (RT) as shown in Figure 5, which presents the cyclic potentiodynamic

The goal of this study was to examine the changes caused in stress corrosion cracking and the critical pitting temperature behavior of a UNS S31803 duplex stainless steel due

No estudo do processo de microfresamento aplicado à fabricação de moldes de microinjeção em aço ferramenta endurecido, Bissacco, Hansen e Chiffre (2005) constataram que

Desta forma, diante da importância do tema para a saúde pública, delineou-se como objetivos do es- tudo identificar, entre pessoas com hipertensão arterial, os

introdução explicita da palavra status seria uma forma objetiva, referencial e direta de mensurar o Status Social Subjetivo (SSS). Já ao aplicar a Escala de MacArthur,

O efeito escala compreende principalmente alguns fenômenos de corte que na usinagem convencional (macro) são desconsiderados e que na microusinagem passam a ser