• Nenhum resultado encontrado

J. Aerosp. Technol. Manag. vol.8 número2

N/A
N/A
Protected

Academic year: 2018

Share "J. Aerosp. Technol. Manag. vol.8 número2"

Copied!
15
0
0

Texto

Loading

Imagem

Figure 1. Spiral Engineering Requirements process (Alves 2007).
Table 2. Concepts drawn from the initial ones.
Table 3 shows cases of concepts belonging to more than one  cluster and helped in the identiication process of existing  common clusters in each map
Table 4. Argumentation lines.
+3

Referências

Documentos relacionados

However, in the case of hybrid airships, there is limited experimental data available for aerodynamic lit generated by the aerodynamic liting proile of hull (alone) and its

he purpose of this section is to present an iterative algorithm for calculating the new equilibrium state of the gas in the inlatable structure chamber ater the

Ater the iring tests, the analysis of the internal surface of nozzle inserts was carried out by EDS through an OXFORD equipment, model 7059, as well as sotware INCA and SEM,

Since most readers of this item will be rather well versed in documents concerning systems engineering, I have elected to share some of the points made on this subject in a

he evaluation of antioxidant performance during thermal ageing was achieved by submitting withdrawn samples to sol/gel extraction, swelling and mechanical testing, dynamical

he composition is less sensitive than RDX in sensitivity tests, it has good stability proprieties and is compatible with the DOPE lacquer used to assemble and seal

ABSTRACT: The design, prototyping, and free-space measurement of a 6-GHz Frequency Selective Surface ilter is presented.. The prototyping resolution of a large (A4 sheet

his paper presented an evaluation of the diference in the IMMPDAF algorithm performance using real and simulated measurements for the same target trajectory. hese radar