• Nenhum resultado encontrado

Lat. Am. j. solids struct. vol.13 número8

N/A
N/A
Protected

Academic year: 2018

Share "Lat. Am. j. solids struct. vol.13 número8"

Copied!
19
0
0

Texto

Loading

Imagem

Figure 2: Schematic configuration of new loading device and specimen (Es'hagi Oskui et al
Figure 3: Schematic of an element near the crack tip.
Figure 4: Contour integral around the crack tip (ABAQUS, V 6.7 2007).
Figure 6: Overview of test rig and set up of the new fixture: (a) mode-I, (b) mixed-mode, (c) mode-II
+7

Referências

Documentos relacionados

The polar nature of the substitute beam, which is a Timoshenko couple-stress beam, is a direct consequence of the pure bend- ing transmission mode components, since through the

For comparison and clarification purposes, the post-buckling behaviour of columns buckling in an “isolated” distortional mode and containing “pure” distortional and

The finite element mesh used in the analysis is shown in Figure 23 and it is formed by 1380 8-node hexahedral finite elements for modeling the pile and cap, 15816 8-8 node

As shown in Figure 7, the UHPC beam with a square opening depth of 16.6% from the depth of beam H100 exhibited a similar response to the hollow beam (H), but the capacity

El-Karamany and Ezzat applied fractional order theory to perfect conducting thermoelastic medium (El-Karamany & Ezzat, 2011; Ezzat & El-Karamany, 2011), Sherief and

In Table 2, the result of first dimensionless fundamental natural frequency parameter….

The mobile phase used was 65% (v/v) acetonitrile in ultra pure water and the best separation was obtained using a flow rate of 7.0 µ L min -1 with isocratic elution mode at

No romance, essa consciência pode ser verificada por meio da técnica monólogo interior livre, pois não há interferência do autor, e também, por meio da técnica solilóquio,