Mat. Res. vol.7 número2

Microstructural analysis of the different test specimens characterized the contact surfaces between the aluminium sheets and the fiber/resin matrix. In most of the specimens,

The addition to Argentina of Myotis lavali with specimens collected in the Yungas ecoregion of Salta Province, and Myotis izecksohni with specimens collected in the Fields

It did not present dorsal or ventral spots, with exception of the tail which showed a few dark spots in relation to background: shades of beige (123A) and/or brown (223A,

Plywood specimens produced with the PF resin modified with bio-oil up to 20 wt% had better tensile shear strength (wet condition), modulus of rupture, and modulus of elasticity in

The Artglass and Solidex composites specimens, the no welded group specimens airborne-particle abraded with the different oxide particles showed higher bond strength compared

The goal of this study was to compare the bond strength of two dual-cure resin cements to the Ni-Cr metal alloy, using test specimens with and without any surface

For the 30 min after photoactivation groups (G2, G5 and G8): 1) the specimens were immersed in deionized water for 30 min; 2) surface was cleaned with absorbent paper; 3) the

I' Illustration showing the steps involved in the different experimental procedures: a, dental specimens; b, restoration with composite resin; c, bleaching for 40 min; d,