• Nenhum resultado encontrado

Mat. Res. vol.20 número3

N/A
N/A
Protected

Academic year: 2018

Share "Mat. Res. vol.20 número3"

Copied!
13
0
0

Texto

Loading

Imagem

Fig. 1. Al-rich corner of the ternary Al–Mn–Fe phase diagram adopted from ref. 14
Fig. 2. The Bridgman–type directional solidiication furnace
Fig. 3. The shematic illustration of rod spacings measurements from the longitudinal  and transverse Sections
Figure 6 shows the microstructures of the studied alloys  with Fe content varying from 0.5 wt.% to 5 wt.% in the range  of V (8.3-978 μm/s)
+6

Referências

Documentos relacionados

study on the effects of iron content and cooling rate on the cell growth of hypoeutectic Al-Fe alloys and further on the development of tensile test parameters like ultimate tensile

The mechanical properties and microstructure of aluminum matrix composites containing of zircon (10, 15 and 20 wt.%) as a reinforcement particles and cobalt additive (1, 1.5 and

Effect of the temperature gradient, growth rate, and the interflake spacing on the microhardness in the directionally solidified Al-Si eutectic alloy.. Journal of

Water glass modification with the colloidal solution of ZnO nanoparticles in propanol confirmed the effect of modifier on the water glass wettability of sand

Descriptive statistics for measuring the surface area the primary precipitates of intermetallic phases IM_W\ κ I (Sap_IM_W\ κ I, μ m 2 ) depending on the annealing time ( τ _ia,

The growth undercooling of grey eutectic is markedly influenced by the growth conditions of graphite (i.e. Gibbs-Thomson coefficient and branching mechanism).. This

His research interests mainly focus on TiAl alloy preparation; microstructure and mechanical properties of bulk nanostructured and ultraine grained Ti based alloys and

Effect of the temperature gradient, growth rate, and the interflake spacing on the microhardness in the directionally solidified Al-Si