• Nenhum resultado encontrado

J. Braz. Chem. Soc. vol.25 número9

N/A
N/A
Protected

Academic year: 2018

Share "J. Braz. Chem. Soc. vol.25 número9"

Copied!
8
0
0

Texto

Loading

Imagem

Figure 2. Regression coefficients for the PLSR model developed for  reflectance data.
Table 2. Analytical figures of merit for PLS models for the properties  of interest
Figure 4. Reference values versus estimated values by the PLSR models  for absorbance (a) and reflectance (b)

Referências

Documentos relacionados

The accuracy was obtained by the evaluation of 4 multielement standard solutions with concentrations belonging to the working range: 0.2, 0.5, 1.0 and 5.0 mg L −1 , added to

In the present study, a multivariate optimization of the QuEChERS method coupled to GC-ECD was proposed to evaluate important variables of the extraction process and investigate

The decomposition after a third reuse cycle is not a great problem because the compounds formed could be calcined to reform the calcium oxide (CaO) and the glycerol synthesized

fact that the reduced pressure of the spray chamber resulted in a decrease of the analytical signal for all elements, no significant differences were observed on the LODs, and

crosslinking allowed a higher thermal stability and improved the mechanical behavior of the nanocomposites compared to TPS (tensile strength of 5.7 ± 1.4 MPa and Young’s modulus

Square wave voltammograms of the APAP oxidation (a) and NAPQI reduction (b) in a presence of different concentrations of glutathione (a) 0-5 µmol L −1 and (b) 0-7.2 µmol L −1

Equipment 757 VA Computrace (Metrohm) was used with a three electrode cell for differential pulse polarography technique: multimode mercury working electrode (MME),

Also, using DDECNPE as the working electrode, we obtained the linear range simulation of the calibration curve for AC and FA as 50.0-1200 and 67.0-1600 µmol L –1 and the.