Lat. Am. j. solids struct. vol.13 número6

In Section II, the derivation and solution to the equations of motion for the beam-pedestrian system are acquired and based on this, the equations of motion for the

According to Blaauwendraad and Hoogenboom (2002), SPanCAD runs three types of analysis, divided by three steps: in step 1, a linear-elastic analysis is made and the

The test results also proved that using distortional buckling strength (Msd) into existing M-V interaction equation predicted reasonable results for specimens without web

Figure 12 depicts the axial load versus the sum of the fastener forces on the second stud from left to right on the sheathed wall-stud model (see Figure 8(a) for distribution

The simula- tion results show that the established finite element model can accurately simulate the crushing process of composite sinusoidal specimens; the failure process of

It is clear from this figure that giving a non-null standard deviation would leads to a dispersion about the nominal response amplitude, which is impossible since there is no

In this work the tensile tests were studied, the results ob- tained show that the type material, the overlap length, the angle of the rolling direction and the thickness of the

The aim of this research was to determine variations in temperature and moisture content in leaves and twigs in yerba maté at the heat treatment step, using heat and mass