• Nenhum resultado encontrado

J. Microw. Optoelectron. Electromagn. Appl. vol.12 número1

N/A
N/A
Protected

Academic year: 2018

Share "J. Microw. Optoelectron. Electromagn. Appl. vol.12 número1"

Copied!
9
0
0

Texto

Loading

Imagem

Figure 2.   Mobile unit and receiver setup
Figure 3.   Measured path loss in single transmitter scenario.
Figure 5.   Cumulative distribution of transmission loss in SFN and single transmitter scenarios
Figure 6.   Power delay profile – measurement point 6.
+2

Referências

Documentos relacionados

A simple configuration of the rectangular microstrip antenna allows operating a system of satellite communication in two bands.. The configuration consists of a

It must be underlined that in the air gap of the IPA there are the effects of two sources of magnetic flux: the first one is a result of the travelling magnetic field produced by

The proposed fabricated antenna with the total length of C-slot L slot confirms the measured notched.. frequency 5.5 GHz as shown

It was due to a proper choice of the pump signal frequency regarding to the input signal that brings about a trade-off between four-wave mixing optical reshaping and

This work presents strategies for planning and performance evaluation through an empirical study of the QoS parameters of a voice over Internet Protocol (VoIP) application in

Abstract — We present a holey fiber (HF) with elliptical air-holes located in the center core area that ensures high birefringence, near-zero ultra-flattened

A novel 3 rd order WLAN U-band pass filter with two transmission zeros for sharp transition band using DGS, coupling matrix and multilayer technique has been

As shown in these figures the conventional (design A) ZOR is designed by using two coupling slots at the input and output ports, whereas proposed ZOR is designed