• Nenhum resultado encontrado

J. Braz. Soc. Mech. Sci. & Eng. vol.26 número1

N/A
N/A
Protected

Academic year: 2018

Share "J. Braz. Soc. Mech. Sci. & Eng. vol.26 número1"

Copied!
6
0
0

Texto

Loading

Imagem

Figure 1. Schematic representation of the USM apparatus.
Figure 2. Variation of the cutting rate (CR) as a function of the cutting  depth (p).
Figure 3. SEM micrographs of ultrasonically machined surfaces with SiC  grits of 15 µm
Figure 4. Relationship between the cutting rate (CR) with the mechanical  properties of workpiece materials
+2

Referências

Documentos relacionados

machining with alumina base nano-ceramic tools T1 and T2. This shows that the tools maintain their hardness at higher speed conditions. Cutting forces generated when machining

This Ra value shows that the radial depth of cut, feed per tooth and tool overhang used in this work are suitable for reaching surface roughness values good enough to obtain a

Those tests were essentially aimed to the comparison of the material presently used for engine blocks, cast iron FC-250, with the compacted graphite iron class CGI-550..

The problem was to choose the near-best values of three control variables (welding voltage, wire feed rate and welding speed) based on four quality responses (deposition

The proposed modified Fowler-Milne method, based on a linear distribution of the particle density instead of a Maxwellian one, at temperature below 10,000 K, showed very useful

Using rapid molds, pre-series of parts are obtained in record time with the injection molding material chosen to manufacture the final parts.. So, tests may be extended to a

Samples cut from tensile test specimens in the tension axis direction were used for dilatometry tests, performed in an Adamel Lhomargy LK02 equipment, in the temperature range from

This innovate mapping system is being used in grinding process to detect inefficient dressing cycles, unbalancing and vibrations detection, non-uniform interaction between wheel and