• Nenhum resultado encontrado

Lat. Am. j. solids struct. vol.7 número3

N/A
N/A
Protected

Academic year: 2018

Share "Lat. Am. j. solids struct. vol.7 número3"

Copied!
21
0
0

Texto

Loading

Imagem

Figure 1 Surface bonded piezoelectric plate.
Table 1 Material properties and dimensions.
Figure 3 Beam deformation for 1 volt, applied across the thickness.
Figure 5 Configuration of smart cantilever plate with piezoelectric patches.
+7

Referências

Documentos relacionados

Figure 1 displays the transverse displacement response of a clamped-clamped uniform Rayleigh beam under the action of concentrated forces moving at variable velocity for various

exact modal analysis, dynamic stiffness matrix, secant method, power

imperfection, steel, plate, stiffener, both-sides corrosion, ran- dom thickness surface model, ultimate strength, buckling strength, behaviour, nonlinear finite element

To understand the effect of lateral cyclic load on lateral ca- pacity of pile group in soft clay, a series of laboratory exper- iments were performed on model piles in soft

Figures 19 and 20 plots the variation of first and second critical speeds successively of the same graphite-epoxy composite shaft with ratio L/D = 20 according to the lamination

Thus, even though, in this paper, concrete has been assumed to suffer only isotropic damage for all stress histories, the elastic response of concrete subjected to

de Faria [5] proposed the use of piezoelectric stiffening stresses to create a nonzero traction force acting along the axis of a laminated beam, allowing the application of an

Narayanan and Balamurugan (2003) presented finite element modeling for active vibration control of laminated beams with distributed piezoelectric sensor and actuator