• Nenhum resultado encontrado

Back to the edge: relative coordinate system for use-wear analysis

N/A
N/A
Protected

Academic year: 2021

Share "Back to the edge: relative coordinate system for use-wear analysis"

Copied!
12
0
0

Texto

Loading

Imagem

Fig. 2 View of the sample FLT1-7 during definition of the coordinate system with the S neox: a manual goniometer is used to orientate the region of interest as horizontally as possible and a silicon mold holds the sample in place
Table 2 Descriptive statistics of X/Y shifts on both microscopes
Fig. 4 Boxplots of selected ISO 25178 parameters: Sa, Sq, Sxp, Str, Std, and Vmc. See Fig
Fig. 5 Schematic drawing of translation (a), rotation (b), and tilt (c). A component of translation is included in b and c as well, for readability.

Referências

Documentos relacionados

Da análise dos dados descritivos (média, desvio padrão, amplitude, assimetria e curtose) efetuada às variáveis dos dois grandes grupos de questões do

It has been shown that the reinforcing effect of ceramic by resin-coating is impacted by the elastic properties of the resin luting agent and that the use of resin luting agents

Desta forma, diante da importância do tema para a saúde pública, delineou-se como objetivos do es- tudo identificar, entre pessoas com hipertensão arterial, os

Although the epoxy resin showed good interaction with the HAp, high polymer content was achieved and the flexural strength of the composite was higher than that of the original resin

Figure 4 shows the variation of the lexural rupture strength of the neat epoxy as well as the epoxy matrix composites reinforced with up to 30 vol% of continuous and aligned

successfully coated onto the surface of ferrosilicon powder; coatings of epoxy resin contributed to the decreased the rate of weight loss via the reduced wear of the coatings

The impedance converter was calibrated with an 1MΩ resistor, the interdigital sensor was embedded in epoxy resin and frequency scanning was performed to ind the frequency with

ABSTRACT: The focus of this study is to evaluate the effect of carboxyl and amino functionalization of multi- walled carbon nanotubes on the mechanical property of the epoxy