Development of environmentally friendly cast alloys and composites. High zinc Al-base cast alloys

The dark phase, also detected using EDX, proved to be very heterogeneous in composition, and this was attributed to the as-cast state of these alloys.. XRD spectra showed a shift

Grain refi ning mechanism of a carbon addition method in an Mg-Al magnesium alloy. Reply to comments on “Grain refi ning mechanism of a carbon addition method in an Mg-Al

It is thus clear that the corrosion behavior of the as-cast binary Mg-Bi alloys was mainly controlled by the fraction of the second phase particles rather than the grain size..

We also determined the critical strain rate (CSR), understood as the tangent of the inclination angle between the tangent to the crack development curve and the crack development

Melt No.. It allowed for the assessment of the influence of aluminium added in the quantity falling into the concerned range on both the graphitization of cast iron

compared to the cast iron treatment using master alloys, the operation of cast iron nodularising by PE technique is additionally very promising since it provides safe

The grain refining efficiencies of the master alloys are affected by many factors which include size, morphology of the grain refiner, melt holding time, melt

The inoculation of yttrium was found to enhance the grain refinement effect of Al-5Ti-1B grain refiner and improve the mechanical properties.. The optimal weight percentage