• Nenhum resultado encontrado

J. Braz. Soc. Mech. Sci. & Eng. vol.25 número3

N/A
N/A
Protected

Academic year: 2018

Share "J. Braz. Soc. Mech. Sci. & Eng. vol.25 número3"

Copied!
7
0
0

Texto

Loading

Imagem

Figure 2. Inherent error versus number of averages in FAS algorithm.
Table 1. Inherent errors due to the signal and lighting variation.  Deformation  Parameters  u  (pixel)  v  (pixel)  ∂ u/ ∂ x  ∂ u/ ∂ y  ∂ v/ ∂ y  ∂ v/ ∂ x  Both images with
Figure 9. Strain ∂∂u/∂∂x along the line ab at a circular disk subjected to 3910  N.
Figure 10. Strain  ∂∂v/∂∂y along the line ab at a circular disk subjected to  3910 N.  -0.005-0.004-0.003-0.002-0.00100.0010.002 0 5 10 15 20 location (mm)γxy TheoryN-RFAS
+2

Referências

Documentos relacionados

Energy levels are calculated using the CLFs obtained via the proposed methodology and compared to those calculated via the analytical expressions given by Cremer et al.. A

Analysis of a Porous Exponential Slider Bearing Lubricated with a Ferrofluid Considering Slip Velocity A porous exponential slider bearing was studied with a ferrofluid

It can generate tetrahedrizations of the aquatic system in question by working according to a procedure which builds, successively, reliable candidates for the following entities:

To evaluate the power developed by the vehicle engine from the measurements of acceleration time, the following data available from the vehicle manufacturer was considered in

Contrary to that observed with austenitic stainless steel, the PSD graphs of high-speed steel tests showed that the dynamic behavior was similar for all the tested

Another advantage of the spatial filters over most of the fixed grid filters is that controlling the area of influence of the spatial filter, it is possible to control the

- the distributed heat source in the proposed solution is an important correction for the known model with point source, since this factor allows to obtain temperature values

In order to investigate the influence of the stacking sequence on the dynamic behavior of the components, experimental and numerical analysis using the Finite Element Method have