• Nenhum resultado encontrado

Lat. Am. j. solids struct. vol.11 número2

N/A
N/A
Protected

Academic year: 2018

Share "Lat. Am. j. solids struct. vol.11 número2"

Copied!
19
0
0

Texto

Loading

Imagem

Table 1   Conditions of loading of parts with control of the elastic-deformable state (see various conditions of loading of parts with control of the elas- elas-tic-deformable state (1 – Model; 2 – Method of fixing, loading conditions, type of elastic line
Figure 2   Schematic of the experimental stand for the testing of elastic deformations of parts
Figure 3   Experimental dependence of elastic shaft deformation (of  length  L  = 300 mm and diameter  d  = 4 mm ) loaded with axial force  F x1  = 1960N (a) and 980N (b)
Figure 4   Objective functions and changes of tensile force  F x 1  in relation to the machining length obtained in the case of various  models (1-3 – numbers designating models from Table 1)
+2

Referências

Documentos relacionados

In a previous study, Zhang and Yu (2012) employed ping-pong balls to study the dynamic buck- ling behaviors of spherical shells impinged onto a rigid plate by means of air-gun

Analytical solutions for the buckling configurations of beams and the natural frequencies of vibration around the buckled beam are obtained for a variety of non-classical

The success of LAJSS is due to authors, readers and reviewers, and I would like to thank them for the continuous and tireless effort to promote a journal that only aims to

Next, matrix cracking was modeled by degrading the properties of the matrix and interfacial damage was modeled by introducing fric- tional cohesive surfaces on the bundle/matrix

The numerical results provide better insight into the effect of stiffener configurations on the nonlinear dynamic response of the stiffened plates subjected to

Latin American Journal of Solids and Structures 11(2014) 200 - 222 Figure 2 Ratio of the elastic modulus of the microcellular foam over the solid polymer elastic modulus as

The present methodology for the pre-sizing of reinforced panels under compressive loads is based on the synthesis of four stability criteria in the simple metamodel depicted in Fig.

The nanocomposite mass in the matrix changed the elastic properties of the plates and the coupling frequency mode moved inside the range of the experimental