Mat. Res. vol.12 número2

wear rate; coefficient of friction versus roughness; and coefficient of friction versus wear rate is obtained, respectively, for epoxy based and waste material blended

The effects of operating parameters like gas flow rate, lance height, and different kettle and lance dimensions on the residence and mixing time were obtained.. The understanding

The effect of experimental parameters on the deposition rate and the coatings performance, including corrosion resistance, interfacial adhesion strength and hardness,

The combustion mode, propagation velocity of combustion wave, combustion temperature and product structure were investigated.. The combustion wave propagated along a spiral

Mechanical property (hardness) and tribological properties (wear and coefficient of friction) were investigated to deduce the optimum manufacturing parameters and

The probability of attending school four our group of interest in this region increased by 6.5 percentage points after the expansion of the Bolsa Família program in 2007 and

Roughness parameters of the TC are shown in the effects plots of flame spraying parameters onto surface roughness (Figure 7). This means that only combustion gases ratio had

This paper aims to investigate the effects of quenching parameters (temperature and time of austenitizing and cooling rate) on the microstructure, hardness and distortion of AISI