J. Braz. Soc. Mech. Sci. & Eng. vol.34 número2

In addition, a new approach for the numerical simulation of the Light Resin Transfer Molding (LRTM) process was developed in this work, demonstrating the viability of

, is a higher than usual concentration in combustion of hydrocarbons, but it can represent situations where soot formation is intensified to supposedly increase

The numerical results for the axial buckling of CNTs are derived and the proposed beam model based on nonlocal boundary conditions is validated through comparison

Despite the changes in the roughness parameters and friction coefficient during the pitting tests, the values of maximum contact stress do not show significant changes

Thus, for the first time, it is shown that, b-parameter from the peak amplitude distribution of AE signal, skewness and kurtosis for statistical distribution

The first period is one of slow rate of growth (controlled by the effect of interfacial tension), the second period is one in which the bubble reaches its

In this paper some shallow water solutions found in the literature are compared with numerical simulations that use the complete motion equations (without the

It can be concluded that increasing the burning time increases the emission, because during the combustion process the material releases its emission.. Effect