Maximum force
Rev. bras. ortop. vol.47 número2 en v47n2a15
... were: control group (CG) of 51.5 N ± 7.9 N; EG II 17.2 N ± 7.8 N; EG III 16.6 N ± 12.1 N; and EG IV 30.3 N ± 7.8 N. There were statistically significant differences between the control group and the experimental groups ...
6
Rev. bras. cineantropom. desempenho hum. vol.14 número1 en a05v14n1
... the force and velocity parameters obtained in SJ and CMJ performed by sprint runners and volleyball ...normalized maximum force and peak velocity were greater in the group of sprint runners, both in ...
11
TEXTURE ANALYSIS OF SPELT WHEAT BREAD
... and relative elasticity (%) – ratio between the remaining force measured 20 seconds after the maximum force was reached and the maximum force. They were evaluated in six replicates and ...
7
Lat. Am. j. solids struct. vol.12 número2
... the force-time and displacement-time graph of the ...the maximum force and minimum deflection values, while the beam with the layup of [90] has the minimum force and maximum deflection ...
22
Reliability of tethered swimming evaluation in age group swimmers
... that force exerted in water is a major factor to enhance swimming performance (Barbosa et ...the force exertion that a swimmer can produce in the ...average force was a reliable parameter to ...
8
THE INFLUENCE OF DIFFERENT CONDITIONS ON THE TEXTURAL PROPERTIES OF MEAT DURING GRILLING
... (Fmax; force needed to attain a given deformation - maximum force penetration during the first cycle; N), cohesiveness (strength of the internal bonds of meat – ratio of the positive force ...
6
Braz. J. Chem. Eng. vol.22 número2
... Typical force-deformation curves showed many fracture points between the initial compression and deformation at maximum force. This indicates a crispy characteristic, since crispness is associated ...
8
Maximum Bite Force Analysis in Different Age Groups.
... Bite force was assessed by measuring the maximum force of bites, using a digital dynamometer model DDK/M (Kratos, São Paulo, ...of force applied by an individual at the time of a ...kilogram ...
5
J. Soc. Bras. Fonoaudiol. vol.24 número4 en a15v24n4
... tongue force (lingual tonus) and instrumental assessment of axial tongue force, which was accomplished by using the ...the force values regarding the variables body mass index classification and ...
5
Dental Press J. Orthod. vol.22 número2
... and force degradation of orthodontic elastomeric ligatures in different stretching patterns during a 8-weeks ...the maximum color changing, and gray elastomers of two brands (American Orthodontics and Ortho ...
10
Quark Confinement and Force Unification
... new force nature that requires the QCD “equivalent of the photon”, the gluon, to not only mediate the force as does the photon, but also participates in it (requires glueballs to ...new force nature ...
4
Wheel Force Transducer for Shimmy Investigation
... a force acting on the wheel, parallel to the spindle axis, involves an increase of the compression in a load cell and the decompression of the other ...the force acting on the ...
6
Rev. Bras. Ensino Fís. vol.34 número2
... a force density, which we call Maxwell’s force density, which generalizes the Lorentz force density, now including total fields rather than only external fields, and arbitrary charge and current ...
5
Measuring Force System Set-Up
... The initial tests conducted dry and replicated using cutting oils, show us, the most physically significant factors leading to safe conclusions were detected that could be introduced to the stochastic models. In the ...
4
Static Analysis of G+2 Institutional Building in Bhopal
... like maximum bending moment, maximum shear force, maximum axial force, maximum joint displacement and maximum section displacement are evaluated and effective and critical ...
9
MECHANICS AND MATERIALS IN DESIGN
... holder force there is wrinkle usually in the flange of the drawn part, when increasing wrinkle is ...holder force will cause fracture in the material. The press force capacity can be calculated by ...
16
2-D Urans Simulations of Vortex Induced Vibrations of Circular Cylinder at Trsl3 Flow Regime
... lift force acting on it as if it is not moving. This force is then used to find the new displacement at the next time ...fluid force but it must be indicated here that the change in this force ...
8
Braz. J. Phys. vol.34 número1A
... In our study, we have shown that a high density system like a neutron star can hold huge charge of the order of 10 20 Coulomb considering the global balance of forces. With the increase of charge, the maximum mass ...
5
Rev. bras. cineantropom. desempenho hum. vol.13 número3
... The force platform was attached to a support inside the pool and was completely submerged against the turn wall of lane three. The aim of the support, which was L-shaped and measured 0.70 x 0.54 m, was to sustain ...
6
Buoyant force in a nonuniform gravitational field
... upward force with a magnitude that agrees to AP, which also explains the origin of the ...net force exerted by a fluid on the portion S of a body that effectively touches the fluid and then a gradient version ...
5