Test method
Steel reinforcement for tires - Test method development to assess the adhesion of steel reinforcements to rubber under dynamic conditions
... dynamic test on samples containing the new desired composition (new compounds with reduced incorporation of resorcinol) able to achieve results that match the tire real condition, using a less time consuming ...
94
Steel reinforcement for tires - Test method development to assess the adhesion of steel reinforcements to rubber under dynamic conditions
... a test method to assess the adhesion performance between steel cord and rubber in tire service conditions, ...this test method would be used to compare the real adhesion performance of 3 ...
65
Use of the D test method to detect inducible clindamycin resistance in coagulase negative staphylococci (CoNS)
... a method to evaluate the inducible clindamycin resistance in accordance with an approach of the disks of erythromycin and clindamycin – the D test – has been ...this method in 200 coagulase negative ...
3
Test method development for textile helix cord angle analysis
... The first step in the test method development was to test the equipment available and define the adequate installation setup. As stated before, three cameras were available for testing. To proceed to ...
58
Investigation of composite coated Ti-C-N surfaces with ball-cratering test method
... 2 3 ' @ + Figure (7) shows the microscope image of the uncoated and coated substrate after ball cratering wear test. In Figure (7a and b) shows the abrasive marks, pits, cracks and wear tracks on the uncoated ...
7
Performance of the Dot-blot test method for detecting antibodies to Sarcocystis spp. in cattle
... In order to investigate antibodies against N. caninum and T. gondii, serum samples were used at the dilution of 1/64 (Devens et al. 2014) in phosphate-buffered saline solution (PBS; phosphate 0.1M, NaCl 0.33M, pH 7.2). ...
4
Test Method development to assess the adhesion of tire reinforcements to rubber under dynamic conditions
... Adhesion Test after waiting for a period of 48 hours, it is easy to verify that for the angles of 0° and 90°, the behaviour is extreme, due to the fact that the stiffness is very high for 0° and low for ...the ...
79
Abrasive Wear Resistance of the Iron- and WC-based Hardfaced Coatings Evaluated with Scratch Test Method
... Abrasive wear tests are carried out on the scratch tester under the dry conditions, in ambient air at room temperature ≈ °C . A schematic diagram of scratch testing is presented in Figure . Stylus indenter was pressed ...
5
Comparison between E-test and CLSI broth microdilution method for antifungal susceptibility testing of Candida albicans oral isolates
... E test method could be considered an alternative to trial routine susceptibility testing due to its ...reference method, since a complete agreement between both methodologies has not been reached, as ...
4
Antimicrobial susceptibility of Campylobacter jejuni subsp. jejuni assessed by E-test and double dilution agar method in Southern Chile
... Table shows the MICs of the six antimicrobial agents tested. Using both metods, no strain was found to be resistant to ciprofloxacin, erythromy- cin and gentamicin, but all were resistant to aztreonam showing MICs ≥ 256 ...
3
Dynamically rotate and free for test: the aath for FPGA concurrent test
... new test challenge: to assure a continuously fault free operation independently of the circuit present after the reconfiguration ...concurrent test method, recently proposed by the authors and based ...
8
Test automation framework
... ness. Test validaty is also assured because we have complete control over the test cenarios, which means, the tester can setup a virtual machine on the network with whatever software characteristics he ...
129
Four Square Step Test e L-Test são alternativa ao 6-Minute Walk Test em amputados de membro inferior?
... RESUMO: Objetivos – Averiguar se o Four Square Step Test (FSST) e o L-Test constituem uma alternativa ao 6-Minute Walk Test (6MWT) para a avaliação de desempenho em amputados de membro inferior. ...
6
Standardization of a computerized method for calculating autonomic function test responses in healthy subjects and patients with diabetes mellitus
... manual method of measuring heart rate (HR) and heart rate response (HRR) to the Valsalva maneuver, standing and deep breathing, with those obtained using a computerized data analy- sis system attached to a ...
9
Correlação do Four Square Step Test e L-Test com o 6-Minute Walk Test em amputados de membro inferior
... The Timed “up and go” test: reliability and validity in persons with unilateral lower limb amputation. Life Habits and Prosthetic Profile of Persons With Lower-Limb Amputation During Re[r] ...
18
DLNA test suite
... After the program debug phase, a scheme of the Test Suite architecture was draw and Figure 4.1 shows the most important parts. User Controls represents any input introduced by the user ”mouse clicks”. The Device ...
124
Test Coverage Analysis
... the test execution process once ...new test execution process will not override them - new coverage data is simply added to the existing ...the test suites themselves are ...large test script ...
83
CUTANEOUS NOCICEPTIVE TEST IN HORSES BY ALTERNATIVE METHOD
... In experimental designs with multiple repetitions, it is possible that the animals develop conditioned reflexes to the lighting of the lamp or even the positioning of the apparatus with the light bulb laterally to the ...
8
Method of using increasing levels of substitution of the basal diet by test feedstuffs in pig digestibility trials
... In order to study the economic viability of each experiment diet, diet cost (DC) was calculated along with feed cost per kg of body weight (ADI), according to Bellaver et al. (1985). The economic efficiency index (EEI) ...
10