The Boundary Element Method
Dynamic stationary response of reinforced plates by the boundary element method
... of the direct version of the boundary element method has been pre- sented to analyze the stationary dynamic behavior of the reinforced panel ...structures. The ...
18
Determination of the effective elastic modulus for nodular cast Iron using the boundary element method
... using the boundary element method (BEM) for modeling a two-dimensional (2D) and three-dimensional (3D) multiphase microstructure is ...considering the graphite nodules as cylindrical ...
17
Buckling Analysis of Laminated Anisotropic Kirchhoff’s Plates via The Boundary Element Method
... for the problem of anisotropic Kirchhoff plates with the action of compressive and shear in-plane forces combined with an out-of-plane ...perturbation. The critical loads for several ...
23
Lat. Am. j. solids struct. vol.8 número3
... to the research in [46], for modeling of sensors and actuators frequently boundary element method (BEM) based formulations have to be coupled with finite element method (FEM) ...
30
Lat. Am. j. solids struct. vol.10 número3
... and boundary supports. If these conditions are more complicated, the classical analysis methods become increasingly tedious or even ...are the only approaches that can be employed for the ...
22
J. Braz. Soc. Mech. Sci. & Eng. vol.34 número2
... Section III provides a brief description of the Boundary Element Method, discusses the numerical model used in this work, and presents its validation based on the[r] ...
6
Constructing efficient substructure-based preconditioners for BEM systems of equations
... that the boundary element method (BEM) is derived from the exact boundary-integral representation of problem solutions, in closed or open domains, accounts for the ...
10
Lat. Am. j. solids struct. vol.13 número16
... considering the effect of seabed con- figurations and soil ...end, the Boundary Element Method is used to irradiate waves, so that force densities can be obtained for each ...
23
J. Braz. Soc. Mech. Sci. & Eng. vol.33 número4
... that the use of a parallel computing approach is required to obtain solutions within a reasonable ...(GPGPU). The Graphics Processing Unit (GPU) is specially well-suited to address problems that can be ...
8
Lat. Am. j. solids struct. vol.9 número2
... between the Boundary Element Method (BEM) and the Finite Ele- ment Method (FEM) in order to create a computational code for the analysis of geometrical nonlinear 2D frames ...
24
Identification of boundary heat flux on the continuous casting surface
... In the paper the numerical solution of the inverse problem consisting in the identification of the heat flux on the continuous casting surface is ...presented. The ...
6
Lat. Am. j. solids struct. vol.14 número7
... handling the inherent singularity diffi- culties associated with crack analysis, mesh-reduction methods present an avalanche of formulations in the literature which, some- times, entails modifications to ...
25
Sensitivity analysis of 3D frictional contact with BEM using complex- step differentiation
... of the complex step differentiation method applied to a parameter sensitivity analysis for 3D elastic contact ...problem. The analysis is performed with the Boundary Element ...
17
J. Aerosp. Technol. Manag. vol.9 número3
... immersed boundary method using control volume inite element scheme was introduced for discretization of governing ...this method is that boundary conditions are implemented by ...
14
Lat. Am. j. solids struct. vol.13 número7
... simulate the transient response of very large floating structures (VLFS) subjected to unsteady external loads as well as moving ...mass. The proposed procedure employs the Boundary ...
20
Lat. Am. j. solids struct. vol.14 número6
... EFG method is a very promising method for the treatment of partial differential ...of the absence of element connectivity, node particles can be added without the need for re- ...
23
An inverse model for locating skin tumours in 3D using the genetic algorithm with the dual reciprocity boundary element method
... in the proximity of the optimum point should be monitored in order that the algorithm does not find just any point in the search space, which might be far from the region being ...which ...
21
ANALYSIS OF STRENGTH OF BRITTLE MATERIALS UNDER DIFFERENT STRAIN RATES USING LDEM SIMULATIONS
... in the literature to study these ...finite element method (FEM) and boundary element method (BEM), to solve a problem where a fracture could ...and the cohesive interface ...
20
Lat. Am. j. solids struct. vol.14 número9
... finite element methods includ- ing the curvature-based finite element method (CFE) and the curvature-derivative-based finite element method (CDFE) are developed for ...
19
Lat. Am. j. solids struct. vol.12 número5
... Function Method (MGGFM) is an integral technique that is characterized by good accuracy in the evaluation of boundary ...This method uses only projections of the Green's Function for ...
22