[PDF] Top 20 Comparison of Morphological, Electrical and Optical Properties of as-deposited and annealed InSe Thin Films

... on electrical conductivity (σ) has been studied both for the as-deposited and annealed InSe thin ...as-deposited and annealed InSe films ... See full document

... cell and holographic recording systems. SnSe thin films of the thickness of 100 nm were deposited by thermal evaporation method on a Glass substrate at room ...compositional, ... See full document

... post annealed at 623 ...the deposited to the post annealed films and the orientations of the films also changed with the post ...considered and annealed at ... See full document

... as-prepared and annealed CdS films are shown in Fig. 8 and the determined bang gap values are listed in Table ...The annealed samples show a relative de- crease in band gap with ... See full document

... 共100兲 thin films were successfully produced by the polymeric precursor ...A comparison between the features of these films heat treated in a conventional furnace and in a ... See full document

... analysis of both as deposited and annealed multilayer films were carried out using Shimadzu XRD-6000 X-ray ...the films were exposed to Cu K α source and the scattering ... See full document

... ZnO films, using RF magnetron sputtering method, have been prepared with different thicknesses on silicon and glass ...influence of thickness on the optical and structural ... See full document

... literature of a systematic study of the impedance behaviour of thin films (< 20 ...the electrical and semiconducting properties of thin anodic ... See full document

... temperature, and inexpensive large-scale deposition ...deposition of semiconductor thin films for over forty ...an optical band gap of ...CdS films which including ... See full document

... coatings deposited on various substrates have been studied by several authors [9 - ...CrN and forms nano-particles in ...manner of the CrN-crystals [10, 13] and reduced the friction ... See full document

... ZnTe and CdTe targets are placed in the target holders of the RF sputtering ...bottom of the target holder and temperature to the order of 100°C is maintained on the ...outside ... See full document

... compositions of microcomponents present in particular ...distribution of graphite and other big ...examination of nanosized secondary precipitates, ...carbides and/or nitrides (or ... See full document

... diffraction and Scanning Electron Microscopy (SEM) were used to examine structure and surface morphology of the ...the films grown above 150 C are single phase and polycrystalline in ... See full document

... (222) and (440) planes, which are having relative in- tensity 100 and 35 respectively in the standard XRD data (JCPDS File ...(222) and (440) planes. Figure 1 (c and d) shows the XRD pattern ... See full document

... part of the study describes the methods used to determine Weibull modulus and the related reliability index of hypereutectic silumins containing about 17% Si, assigned for manufacture of ... See full document

... ways of performing the same task (Roger, 1983; Agarwal & Prasad, ...day and 7 days a week, it provides an enormous advantage and convenience to users (Tan & Teo, ...products and ... See full document

... strength of A356 casting by a maximum of ...addition of yttrium results in finer dendritic structure and more fibrous eutectic phase, this contributes to strengthening effect on the ...Coarse ... See full document

... roughness and mean square roughness first decrease and then, increase to the extent that both the thin films deposited at the substrate temperature of 450ºC and 550ºC have ... See full document

... surface of the same sample in order to verify the homogeneity of the PL ...eV and the near band edge (NBE) emission, at ...intensity of these bands is different at each point, so the PL ... See full document

... Lot of work has been reported by many researchers who worked to study the effect of structures with irregular plan and ...effects of earthquake on irregular shaped building in plan, this paper ... See full document