• Nenhum resultado encontrado

[PDF] Top 20 Experimental Analysis Of Heat Transfer From Square Perforated Fins In Staggered Arrangement

Has 10000 "Experimental Analysis Of Heat Transfer From Square Perforated Fins In Staggered Arrangement " found on our website. Below are the top 20 most common "Experimental Analysis Of Heat Transfer From Square Perforated Fins In Staggered Arrangement ".

Experimental Analysis Of Heat Transfer From Square Perforated Fins In Staggered Arrangement

Experimental Analysis Of Heat Transfer From Square Perforated Fins In Staggered Arrangement

... The fins have a square cross section of 15 mm x15 mm and are attached on the upper surface of the base plate as shown in Fig ...1. Square pin fins with different lengths, ... See full document

8

EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER ENHANCEMENT OVER THE DIMPLED SURFACE

EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER ENHANCEMENT OVER THE DIMPLED SURFACE

... Heat transfer coefficients and Nusselt number were measured in a channel with one side dimpled ...depth of dimple were 6 mm and 3 mm, ...varied from 5000 to ...and staggered ... See full document

7

Enhancement of Natural Convection Heat Transfer from Perforated Fin

Enhancement of Natural Convection Heat Transfer from Perforated Fin

... Pin fins have a variety of applications in industry due to their excellent heat transfer performance ...e.g. in cooling of electronic component, in cooling ... See full document

5

REVIEW OF HEAT TRANSFER ENHANCEMENT IN DIFFERENT TYPES OF EXTENDED SURFACES

REVIEW OF HEAT TRANSFER ENHANCEMENT IN DIFFERENT TYPES OF EXTENDED SURFACES

... the heat transfer characteristics and pressure drop in the channel with V corrugated upper and lower plates under constant heat ...the analysis on channel with two opposite corrugated ... See full document

10

Experimental Study of Heat Transfer Enhancement in a Heated Tube Caused by Wire-Coil and Rings

Experimental Study of Heat Transfer Enhancement in a Heated Tube Caused by Wire-Coil and Rings

... air in the inner tube. To avoid the influence of obstacles as a Fin, a plastic layer was added to the wire coil and ...considered in the experimental study. Air velocity in inner tube ... See full document

8

A Review on Heat Transfer Improvent of Plate Heat Exchanger

A Review on Heat Transfer Improvent of Plate Heat Exchanger

... plate heat exchanger to find out the temperature, volumetric flow rates at all ports and pressure drop at inlet and outlet ports at different channels with Reynolds Number ranging from 450 to ...method ... See full document

6

Characteristics of Homogeneous-Heterogeneous Reactions and Melting Heat Transfer in the Stagnation Point flow of Jeffrey Fluid

Characteristics of Homogeneous-Heterogeneous Reactions and Melting Heat Transfer in the Stagnation Point flow of Jeffrey Fluid

... melting heat transfer in the stagnation point flow of Jeffrey fluid past an impermeable stretching cylinder with homogeneous-heterogeneous ...Characteristics of magnetohydrodynamic flow ... See full document

8

Thermal performance of a porus radial fin with natural convection and radiative heat losses

Thermal performance of a porus radial fin with natural convection and radiative heat losses

... effect of natural convective heat loss on the temperature distri- bution in the fin when the radiation heat loss, the environment temperature, and the ratio of outer to inner radius are ... See full document

10

Internal ballistics simulation of a solid propellant rocket motor

Internal ballistics simulation of a solid propellant rocket motor

... used in most modern solid motors. The grain burns only in its inside surface so the propellant acts as an ...important. In fact, a thin layer of propellant usually remains after burn-out, ... See full document

89

J. Braz. Soc. Mech. Sci. & Eng.  vol.28 número4

J. Braz. Soc. Mech. Sci. & Eng. vol.28 número4

... examination of the actual temperatures of the cycle revealed that the absorption temperature is high, and leads to a poor performance of the absorption ...the heat and mass transfer ... See full document

9

HEAT TRANSFER COEFFICIENT AND FRICTION FACTOR CHARACTERISTICS OF A GRAVITY ASSISTED BAFFLED SHELL AND HEAT-PIPE HEAT EXCHANGER

HEAT TRANSFER COEFFICIENT AND FRICTION FACTOR CHARACTERISTICS OF A GRAVITY ASSISTED BAFFLED SHELL AND HEAT-PIPE HEAT EXCHANGER

... effect of inclination angle over effectiveness of heat@pipe heat exchanger for different inlet temperature of hot ...clear from the plot that the maximum effectiveness of ... See full document

9

Analysis of quality and cost of FeSiMg treatment master alloy vs. cored wire in production of ductile cast iron

Analysis of quality and cost of FeSiMg treatment master alloy vs. cored wire in production of ductile cast iron

... results of studies on the use of FeSi5%Mg magnesium alloy in modern cored wire injection method for production of nodular and vermicular graphite cast irons were ...injection of Mg ... See full document

4

Experimental investigation and comparison of heat transfer coefficient of a two phase closed thermosyphon

Experimental investigation and comparison of heat transfer coefficient of a two phase closed thermosyphon

... length of the thermosyphon consists of three parts; a lower part of 430 mm as the evaporator section, the middle part of 160 mm as the adiabatic section, and a upper part of 410 mm as ... See full document

10

A Heat Transfer Textbook   Lienhard

A Heat Transfer Textbook Lienhard

... flows from hot objects to cold ones. We call that flow heat. In the eighteenth and early nineteenth centuries, scientists imagined that all bodies contained an invisible fluid which they called ... See full document

762

INVESTIGATION OF CONVECTION AND RADIATION HEAT TRANSFER IN RHOMBUS MICROCHANNELS

INVESTIGATION OF CONVECTION AND RADIATION HEAT TRANSFER IN RHOMBUS MICROCHANNELS

... Po=24/(1+12Kn) in Table 1 that shows good agreement. In Table 2, the Nusselt number have been compared with the results of Reinksizbulut [7] for Kn=0 through a range of Reynolds ...case ... See full document

10

Analysis Of Lean Accounting JIT And Balance Scorecard In The Companys Lean Manufacturing

Analysis Of Lean Accounting JIT And Balance Scorecard In The Companys Lean Manufacturing

... people in the restaurant, but chef only cook once and split the 5 then the waiter gives the ...is in the table provided the spice ...concept of lean manufacturing is, if the someone want to buy and ... See full document

8

Performance of water and diluted ethylene glycol as coolants for electronic cooling

Performance of water and diluted ethylene glycol as coolants for electronic cooling

... cooling of microprocessors or other electronic ...removal of heat from a high power density ...a heat spreader and a heat sink ...circulation of liquid metal inside the ... See full document

6

J. Braz. Soc. Mech. Sci. & Eng.  vol.33 número1

J. Braz. Soc. Mech. Sci. & Eng. vol.33 número1

... flows in a fluid saturated porous media are of great interest because of their various engineering, scientific and industrial applications in heat and mass transfer which occurs ... See full document

7

Modeling Heat and Mass Transfer from Fabric-Covered Cylinders

Modeling Heat and Mass Transfer from Fabric-Covered Cylinders

... series of simulations, the cylinder diameter was ...size of human thigh), and the air space between the fabric and the cylinder surface was ...range of air flow velocities from 1 to 40 m/s, ... See full document

8

Numerical computation of solar heat storage in phase change material/concrete wall

Numerical computation of solar heat storage in phase change material/concrete wall

... a heat reservoir to provide thermal comfort by reducing the cooling/heating ...increase in comfort even in the absence of an air conditional ...incorporated in air conditioning systems ... See full document

8

Show all 10000 documents...