Date: 10-12-15 V2.0 PNEG-057
Instructions
1004 East Illinois Street • Assumption, IL 62510 • 1-217-226-4421PNEG-057
Printed in the U.S.A.
Copyright © 2015 by The GSI Group, LLC www.gsiag.com
Page 1 of 2 CN-314487
22" Rotary Unloader Valve
Instructions
Ref # Part # Description
1 S-4378 Plastic Grip
2 HT-1353 Clean Out Plate 3 BLK-10921 Handle Weldment
4 S-4379 Shaft Shim
5 S-4377 Grooved Roll Pin
6 BLK-10994 Handle Bracket 7 BLK-10880 Frontplate Weldment
8 BLK-10340 Slotted Foam Gasket (Three (3) Pieces per Ring) 9 BLK-11096 Backplate Weldment
10 BLK-10871 Maxi-Flo Boot
11 Rotary Unloader Weldment
12 Rotary Gate Weldment
13 Bearing Cover Plate
NOTE: Bearing kit is optional. Use supplied 3/8" x 1" bolts and 3/8"
nuts for boot to bin collar connection.
Use rope caulking around outside edge of holes. Do NOT get any caulking where rotary gate will be rotating.
PNEG-057 Page 2 of 2
22" Rotary Unloader Valve Instructions
Unloader Tube Detail
Figure 1
Install optional bearing kit to unloader if ordered per supplied instruction sheet.
NOTE: 4" Rotary unloaders require 23" of exposed flight.
6" Rotary unloaders require 25" of exposed flight.
8" Rotary unloaders require 27" of exposed flight.
It may be necessary to field cut auger tube lengths to accommodate required exposures. After cutting
(if necessary) butt tube to unloader tube and fasten with connecting band assembly.
IMPORTANT: Unloader is designed to fit 4", 6" and 8" GSI/Hutchison feed tank augers. If using a
different auger supplier, it may require field modification.
Ref # Description
A 12" Connecting Band Assembly B Cut Auger Tube Here (If Needed) C Optional Bearing D 23"-4" Unloaders 25"-6" Unloaders 27"-8" Unloaders CLOSE OPEN
