Science Arts & MИtiers (SAM)

To show the influence that storage can have, two drying simulations with the same global surface area in both collectors were compared: one system without storage consisting of an air

In order to compare the rotor eddy current losses between different combinations, an indicator is developed using the equation 4 on an estimation of the losses induced by a magnetic

Therefore, comparisons of predicted and experimental flow patterns reveal that a better match is obtained for the high friction coefficients in the case of 0.25 m s−1ram speed and for the

On the basis of these estimated models, three amplitude dependent damage indexes are built: one that monitors the shift of the resonance frequency of the structure, another the ratio of

Even if these conductivities are much lower than the one ≈ 0.34 S cm− 1 reported for high molecular weight P3HT polymers chemically synthesized by FeCl3 and doped with I2 Kuila and

Because the only steel that resists LME is the one that shows stability over α’ phase change due mostly to its higher nickel content, a point confirmed by X Ray fractography, it is

The lack of moist air and the sharp strain gradient on the one hand, and the higher stress triaxiality around an internal pore, on the other hand, cer- tainly make fatigue crack

Since one problem of practical importance is to determine the extreme roughness amplitude that will be found in a large scale sam- ple by using a small evaluation length, the procedure