Science Arts & Métiers (SAM)

The behaviour observed in both samples under different conditions suggests that the wear mechanism during the test is the same, and to increase the wear and friction resistance of

Therefore, comparisons of predicted and experimental flow patterns reveal that a better match is obtained for the high friction coefficients in the case of 0.25 m s−1ram speed and for the

Since one problem of practical importance is to determine the extreme roughness amplitude that will be found in a large scale sam- ple by using a small evaluation length, the procedure

The microstructure of this anomaly is only observed in chips: the adiabatic shear band similar to that observed within the chip evolves from a deformed layer to a transformed layer,

After tilt correction, image sources can be aligned on the vertical real source axis to recover the sound speed profile.. Note that the vertical axis is not perpendicular to the sea

It can also be seen that the higher fatigue strength of the 45°-B1 batch compared to the 90° batch is not in agreement with the pore size distributions measured on polished samples of

Finally, these spatial distributions show that this von Kármán vortex shedding is solely related to what occurs in the vicinity of the trailing edge and in the wake, thus highlighting

In fact, in [10, 31, 33– 35], for sinusoidal multiphase machines, it is highlighted that an open‐switch or an open‐phase fault results in a fault current component appearing in