Science Arts & Mйtiers (SAM)

In this paper, residual plastic strain distributions in the machined surface and subsurface, induced by the orthogonal cutting of OFHC copper under practical machining conditions

To show the influence that storage can have, two drying simulations with the same global surface area in both collectors were compared: one system without storage consisting of an air

This rather simple model allows a rapid and easy estimation of the KH depth as a function of the operating parameters incident laser power, focal spot diameter, welding speed and

Bennett and McDowell 2003 have used several mechanical quantities the maximum slip amplitude, an equivalent stress inspired by the Dang Van criterion Dang Van, 1973 and an equivalent

To simulate the adhesion of the reactive fluid on the mold surface, we developed a model to fix the fluid particles when they reached a certain viscosity and when they are exposed to a

sy Yield stress R0 Radius of the plate t0 Thickness of the plate f Half angle of the striker r0 Radius of the striker n Poisson's ratio G Fracture toughness E Young modulus rp

Adding fillers is known to increase the material stiffness see review1, increase its Mullins softening,2 and delay its fracture in monotonous loading3 as in fatigue.4Increasing the

As for FE_45 specimens, the crack density increase depending on tensile strain was found linear until specimen failure, because +45° and 45° layers have the same behaviour and composite