[PDF] Top 20 Effect of the polishing procedure and surface sealant application on fluoride release

... assess the effect of the polishing procedure and surface sealant application on the fluoride release of restorative ... See full document

... study, the resinous material adhesion was found to be influenced by the type of fluoride ...Considering the benefits of the materials that release fluoride, ... See full document

... alterations of denture base jeopardize adaptation and retention associated to altered occlusion, which are considered relevant factors for fabrication of complete ...Objective: The aim ... See full document

... USA) and polished with felt paper and diamond spray (1 ␮m; ...This procedure resulted in removal of a layer of dentine about 200 ␮m ...deep. The surface micro- hardness ... See full document

... from the crown and cervical roots of bovine incisors [ 39 ...from the central part of the dental crown [ 28 ...from the cementum-enamel junction, then cut to a 4 mm size ... See full document

... study the remineralization effectiveness was not assessed. Only the post-remineralization bond strength was ...ICON® application did not either make impossible or damage a further adhesive ... See full document

... for the fluoride release analysis were stored for 1 hour at 37°C and 100% ...Then, the specimens were finished/polished with graded series (coarse, medium, fine, and extra fine) ... See full document

... The surface roughness was measured with a rugosimeter (Surftest-301 serie 15700438 - Mitutoyo, Suzano, Brazil) on the top surface of the ...specimen. The ... See full document

... study, the specimens were exposed to the mouthrinses atevery 12 h for 30 days, situation that mostly approaches to that recommended by the ...composite surface alterations, although it was ... See full document

... enamel surface increase the availability of the fluoride ion, enhancing the remineralizing ability ...In the clinical possibilities of fluoride ... See full document

... degree of polymerization than the rest of the ...situation, the inishing and polishing procedure could contribute to the color stability because it removes ... See full document

... Finishing and polishing procedures require the sequential employment instruments, usually with gradual decrease of abrasive particles, aiming to achieve a shiny and smooth ... See full document

... teeth of the irradiated groups received 70 Gy from tridimensional conformal radiotherapy by using a Linear Accelerator (Clinac 600C, Varian Medical Systems; Corona, CA, USA), fractioned into 2 Gy/ day, 5 ... See full document

... filter and analyzer, using water as the imbibition medium. This procedure enabled observation of the surface lesion and the lesion body in its extent, according to ... See full document

... enamel and dentine slabs (3 × 3 × 2 mm) were obtained from sound bovine incisors, and their external surfaces were polished ...Then, the slabs were isolated with wax; thus, only the external ... See full document

... receiving surface treatment with diamond burs, the Super Snap system (H) produced smoother surfaces than the Sof- Lex system (G) for all materials, suggesting a better ability of the ... See full document

... °C) and application method (capillarity and ...group of products was obtained using waste biomass from mixed microbial cultures (MMC) for polyhydroxyalkanoates production process, grown in tap ... See full document

... , the total dose of Ambroxol hydrochloride for twice-daily SR formulation was calculated using available pharmacokinetic ...dose of 30mg of Ambroxol hydrochloride with a half- life of ... See full document

... finishing and polishing and immersion solutions (artificial saliva, sodium fluoride solution at ...Fluorgard). The specimens remained immersed in artificial saliva for 24 hours ... See full document

... with the same agent (Whiteness HP, FGM, Santa Catarina, Brazil) in all ...groups. The gel was applied to the surface of the samples according to manufacturer’s recommendations ... See full document