[PDF] Top 20 Influence of endodontic irrigants on resin sealer bond strength to radicular dentin

... Committee on Ethics (protocol ...criteria of the roots were as follows: canals up to 3 mm in cervical diameter and at least 15 mm in root ...surface of each tooth was sectioned below the ... See full document

... worn to expose an area of dentin and were divided into 2 groups: Group C (Control) - acid etching with 37% phosphoric acid + Single Bond; Group CHX ...Single Bond. Blocks of ... See full document

... context of associating chemical adhesion with micromechanical adhesion, thus it was added to the primer and adhesive ...advantage of the 10-MDP monomer is increasing bond strength, ... See full document

... identical to the RelyX U100 differing only in the application procedure (35), the smear layer did not dissolve consistently at the cement-dentin interface and hybridization of dentin was only ... See full document

... Dentin is a dynamic substrate,i'' and its morpho- iogicai and functional characteristics are determi- nants of the quality of resin-dentin bonds achieved with adhesive agents.^° Scleroti[r] ... See full document

... ratio of bonded to unbonded surface areas of cavities, in a root canal is highly unfavorable and contributes to maximizing the polymerization stress of resin based materials ... See full document

... aim of the present study was to evaluate the effect of cal- cium hydroxide dressing on the bond strength of three commercially available endodontic sealers (MTA ... See full document

... instruments to remove great quantity of dental tissue, and low speed to finish the preparation before taking an impression, because a smoothest surface is easier to copy and the final fitting ... See full document

... modification of the bonding substrate with chitosan and riboflavin increases the mechanical properties, enhanced the mechanical stability of demineralized dentin substrates against hydrolytic and ... See full document

... Single Bond 2 and the experimental adhesive system present a pH around ...incorporation of chitosan. The study of Elsaka [21] tested the bond strength and pH of adhesives ... See full document

... dental resin adhesives are hydrophobic adhesive monomers, hydrophilic monomers (to improve the wettability of hydrophobic monomers on the demineralized matrix), organic solvents such as ... See full document

... aim of this study was to detect the influence of application mode of cleansing agents, on enamel and dentin during the adhesion process of a one-step self-etching ... See full document

... microtensile bond strength of a total-etch adhesive to dentin, using a CVD tip or diamond bur for dentin preparation and varying the etching ...The dentin from the buccal ... See full document

... amount of cement used was similar, justifying the lack of difference in the bond strength ...is of clinical relevance that the use of the customized post technique with a ... See full document

... purpose of this study was to investi- gate the influence of gutta-percha solvents on the bond strength of fiberglass post to root canal ...according to ... See full document

... effect on restorative material bonding ...irradiated dentin under transmission microscopy and noticed the presence of fused remnants, as well as poorly denatured collagen fibrils attached to ... See full document

... presence of bubbles when different commercial cements were applied for luting an endodontic post using either the conventional application technique or an automix dispensing tip (called ³ÀH[LEOH ... See full document

... rpm) to produce slices of approximately 2 mm ...side of each slice was marked with an indelible ...cross-speed of 1 mm/min. Loads were applied in an apical-to-cervical direction until a ... See full document

... purpose of this study was to evaluate the bond strength between root dentin and glass fiber posts cemented with dual cure resin cement associated with the total-etch and ... See full document

... cleaned of gross debris and stored in distilled water at ...acrylic resin, and the occlusal enamel surface was removed with a low concentration diamond disc mounted on a low- speed laboratory cutting ... See full document