• Nenhum resultado encontrado

Res. Biomed. Eng. vol.33 número2

N/A
N/A
Protected

Academic year: 2018

Share "Res. Biomed. Eng. vol.33 número2"

Copied!
12
0
0

Texto

Loading

Imagem

Figure 1 presents the main modules of a typical FES  device, including:
Figure 2. Generation of modulated signal using Pulse Amplitude Modulation (PAM). The waveforms were captured by a Tektronix TDS 2024B  oscilloscope.
Figure 3. Fluxogram for the execution of queries in IEEE Xplore and ScienceDirect databases.
Table 1. Summary of output stage circuit details described in the retrieved papers.
+3

Referências

Documentos relacionados

The current status and proposed objectives for improving the quality of these two coastal water bodies in Belfast Lough Management Area, is shown in Figure 59....

There are various types of photovoltaic modules based on generation of solar cell and their applications in terms of electrical as well thermal outputs.. If

Este relatório pretende descrever o modo como estas três áreas (modelo de jogo, modelo de treino e modelo de análise do jogo) foram concebidas e operacionali- zadas ao longo de

The oxidation current from naproxen was obtained by subtraction of the current values detected at the two potential pulses, similarly to previous studies which applied MPA

On the other hand, the current crisis of health in Brazil has stimulated the search of alternatives that have shown the adoption of strategies for changes in the current health

Figure 8 shows the current requirement of the device; a current of 17.5 mA is required at the sensor operating temperature 600 o C although the sensor circuit simulation gave a

social assistance. The protection of jobs within some enterprises, cooperatives, forms of economical associations, constitute an efficient social policy, totally different from

The current control loop consists of a hysteresis current controller (HCC). The block diagram of a hysteresis current controller is shown in Fig. HCC is used to