Texto
Vol. 6, No. 2, 2003 Titulo Artigo 377
Materials Research, Vol. 7, No. 2, 2004. © 2004
In the article
A Step Toward Production of Smaller Diameter Single Wall Carbon Nanotubes,
by V. Lemos, D. Silva, C.A. Luengo, J.G. Huber, J.M. Rosolen*, the three catalysts used were the
inter-metallic compounds Zr(Fe0.50Ni0.50)2 and Zr(Co0.50Ni.050)2 and the metal oxide compound Li(Co0.50Ni0.50)O2 and
not Fe:Ni (1:1), Ni:Co (1:1) and LiCo0.50Ni0.50O2, respectively. Erratum (v. 6, n. 1, 5-9, 2003)
Documentos relacionados
The healing process was evaluated using a dermal ulcer model and the results showed a good tissue repair resembling a physiologic process.. The overall results presented here lead
• Solid inclusions grown on seed crystal interface are responsible for the nucleation of dislocation bundles appearing in +X- and –X- growth sectors formed around the Z-axis. •
ing temperatures and holding times. In these cases, the ad- hesion strength between the diamond wafer and the tung- sten carbide substrate was probably higher than the intrin-
Titanium alloy Ti6AL4V ASTM F136 (Ti) and stainless steel AISI 316L (SS) plates were cut into small rectangular samples (20 mm, 10 mm, 1 mm). The plates were metallographically
A good consistency between ER change values is observed in different experiments: thermal martensitic transformation, stress induced martensitic transformation and stress
The aim of this work was to evaluate the effect of light intensity and irradiation time on the polymerization process of a photo cured dental composite resin by measuring the
In this work two different synthesis methods of perovskites, SrCo 0.5 FeO 3 , were compared: combustion synthesis and oxides mixture aiming at evaluating their use as membranes
The obtained results from the dielectric characterization in the microwave region, for the modified lead titanate ce- ramics, confirmed the existence of the dielectric
