Science Arts & Métiers (SAM)

Formalization: Given x, y and z, the three vectors containing the components of the 3D coordinates of the Nn nodes of the bar network coupled to the control vertices of the meshes a

& The slug temperature should be optimised in order to: allow the increase of the material desagglomeration and thus decreases the thixoforging load avoid the collapse of the slug

This can be explained by the fact that the sputtering rate of Al is higher than the Mo one.[10]Finally, as observed in the case of the Cr,AlN coatings and for the same reason, we

Mean grain size obtained after processing by I-ECAP ~5 lm is comparable with results obtained after conventional ECAP at the same temperature.[10] Grain refinement led to formability

The dependency of the deposition probability and the dimensionless surface coverage Γ/ΓRSA on the frequency of the pitches λ, the Péclet number Pe and the favorable area fraction θ, as

The proposed proce- dure AK-ILS takes advantage of several points of the literature review: •the Hammersley sequence for the initial design of experiments, •the Kriging metamodel

Crack delamination appears at inclined drilling in the TBC at the BC/TBC interface at the leading edge but only from the second laser pulse when the laser beam interacts with the

In fact, in [10, 31, 33– 35], for sinusoidal multiphase machines, it is highlighted that an open‐switch or an open‐phase fault results in a fault current component appearing in