Science Arts & Métiers (SAM)

Such a discontinuous behavior was also observed from the melt at a cooling rate of 10C min1in the PLA/talc sys- tem, but no explanation was given.40 The crystallization half time of

& The slug temperature should be optimised in order to: allow the increase of the material desagglomeration and thus decreases the thixoforging load avoid the collapse of the slug

Evolution of mechanical properties of aged polyether ketone ketone explained by a microstructural approach Sébastien Rolanda, Mahdi Moghaddama, Sylvie Tencé-Giraulta,b, Bruno Fayollea

The dependency of the deposition probability and the dimensionless surface coverage Γ/ΓRSA on the frequency of the pitches λ, the Péclet number Pe and the favorable area fraction θ, as

The displacement represents the distance measured by DIC between two points located on the compression diagonal at 45◦to the rails passing through the centre of the shear area

Conclusions The deposition of a 50% WC–Co–Cr/50% Colmonoy 88 coating onto a SAE 4340 steel substrate by thermal spraying gives rise to a deposit with a heterogeneous microstructure and

Crack delamination appears at inclined drilling in the TBC at the BC/TBC interface at the leading edge but only from the second laser pulse when the laser beam interacts with the

In fact, in [10, 31, 33– 35], for sinusoidal multiphase machines, it is highlighted that an open‐switch or an open‐phase fault results in a fault current component appearing in